Texas Road Signs Test

Correct answer: B. A railroad crossing ahead

A crossbuck is a large white X-shaped sign placed before a railroad crossing. It warns drivers that tracks are ahead.

Source: Texas Driver Handbook (DL-7), “Appendix A: Glossary of Terms”, page 71. Handbook PDF

Correct answer: D. A railroad crossing ahead

Round signs are used for advance warning of railroad crossings. Slow down and be ready to stop if a train is approaching.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 26. Handbook PDF

Correct answer: B. Slow down, look and listen, and be ready to yield to any approaching train

The handbook says crossbuck signs are posted at every grade crossing and show where the tracks are. Drivers should slow down, look, listen, and be prepared to yield the right-of-way to an approaching train.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 32. Handbook PDF

Correct answer: D. Only at a marked crosswalk

Pedestrian hybrid beacons are pedestrian-activated devices that are only put in at marked crosswalks, where people enter or cross the street.

Source: Texas Driver Handbook (DL-7), “Chapter 4: Right-of-Way”, page 24. Handbook PDF

Correct answer: B. The start of a no-passing zone ahead

The pennant shape is reserved for advance warning of zones where passing is not allowed. Other hazards use different shapes.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 26. Handbook PDF

Correct answer: B. Attaching it to a stationary object beside the road

The emblem is meant only for slow-moving vehicles. It must not be placed on other vehicles or on objects that are not moving.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 37. Handbook PDF

Correct answer: A. The road ends ahead, so you must turn left or right and be ready to yield

The handbook says this sign warns that you are nearing a T intersection where you can only turn left or right. You should be prepared to yield the right-of-way at the intersection if needed.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 28. Handbook PDF

Correct answer: B. Slow down and steer firmly as you move off

Where the shoulder is much lower than the pavement, reduce speed and hold the steering wheel firmly. This helps you keep control when leaving the road surface.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 29. Handbook PDF

Correct answer: B. The signals or signs posted at the intersection

A controlled intersection is one where traffic signals or signs set the right of way. Drivers must follow those devices rather than relying on size, speed, or arrival order.

Source: Texas Driver Handbook (DL-7), “Appendix A: Glossary of Terms”, page 71. Handbook PDF

Correct answer: C. Slow down and avoid sudden braking or sharp steering

Bridges can ice over, so drivers should reduce speed and avoid abrupt braking or sudden steering movements to keep control.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 28. Handbook PDF

Correct answer: D. Traffic may enter the road from a side road on the right

The handbook's warning sign table says this symbol marks a Y-intersection or side road traffic to the right. Drivers should expect vehicles to come in from the right. The other choices describe a T-intersection, a merging lane, and a sharp turn, which are different signs.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 28. Handbook PDF

Correct answer: A. Look both ways and listen, stopping if a train is coming

With only a crossbuck sign, check both directions and listen for a train. Stop if one is approaching; otherwise go on with caution.

Source: Texas Driver Handbook (DL-7), “Chapter 4: Right-of-Way”, page 22. Handbook PDF

Correct answer: B. Stay in your lane, because passing on the left is prohibited here

The handbook lists signs or markings for a no passing zone among the situations where you must not drive on the left side of the road. So you must stay on your side and not pass, even if the road looks clear.

Source: Texas Driver Handbook (DL-7), “Chapter 6: Signaling, Passing, and Turning”, page 38. Handbook PDF

Correct answer: D. Keep your speed at or below this number to take the curve safely

An advisory speed sign gives the highest speed at which a driver can safely go through the curve ahead. It is a safe-speed recommendation for that curve, not a minimum speed or a school zone limit.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 30. Handbook PDF

Correct answer: D. Reduce speed, drive with extra care, and avoid passing other vehicles

The handbook says this sign warns of a winding road ahead. Drivers should travel at a low speed, take extra care, and not pass, so slowing down and not passing is correct.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 27. Handbook PDF

Correct answer: A. Mounted above the travel lanes at the crosswalk location

Overhead Pedestrian Crossing signs hang over the road at the crosswalk itself. This differs from in-street signs, which stand on the center line, lane line, or median island.

Source: Texas Driver Handbook (DL-7), “Chapter 4: Right-of-Way”, page 24. Handbook PDF

Correct answer: D. A guide sign

Guide signs give drivers information such as directions, distances, services, and points of interest. That makes them the right place to look for the distance to a town or for fuel.

Source: Texas Driver Handbook (DL-7), “Appendix A: Glossary of Terms”, page 72. Handbook PDF

Correct answer: C. To remind drivers of the right-of-way laws at the crosswalk

These signs are used at unsignaled pedestrian crosswalks to remind all road users of the right-of-way rules that apply there, including yielding to people crossing.

Source: Texas Driver Handbook (DL-7), “Chapter 4: Right-of-Way”, page 23. Handbook PDF

Correct answer: B. Watch for traffic in the new lane; merging is not required

This sign warns that an extra lane starts. You do not have to merge, but you should watch for vehicles moving into that new lane.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 27. Handbook PDF

Correct answer: C. Come to a full stop before the crosswalk, then proceed when safe

A stop sign applies to every vehicle that reaches it, and each one must halt completely before the crosswalk or intersection. Merely slowing down does not satisfy the sign.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 30. Handbook PDF

Correct answer: D. It lets the flag person stand outside the traffic lane

An automated flagger assistance device is operated remotely so the flag person does not have to stand in a lane of traffic while controlling the work zone.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 36. Handbook PDF

Correct answer: A. 25 mph

Vehicles built to go no faster than 25 mph, including farm and road machinery, must display the slow-moving vehicle emblem so others can recognize them.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 37. Handbook PDF

Correct answer: A. Check the traffic behind you before moving back over

After clearing channelizing devices, you should go back to your normal lane only once you have looked at the traffic behind you.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 36. Handbook PDF

Correct answer: A. A railroad crossing is ahead

Round signs are used for advance warning of railroad crossings. This yellow round sign tells drivers a crossing is coming up, so they should pay attention and slow down.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 26. Handbook PDF

Correct answer: A. Slow down and check every direction for traffic on the crossing road

The plus-shaped sign warns that a cross road is ahead. The handbook says to slow down and look carefully in all directions for cross traffic. It does not require a stop, and it does not signal a curve or an added lane.

Source: Texas Driver Handbook (DL-7), “Chapter 5: Signals, Signs, and Markers”, page 27. Handbook PDF